Hot-Rod Internet Bench Racing
Welcome to the only Aussie Rodders Forum on the Internet
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   Register 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log in 

HYDRAULIC THROW OUT BEARING

 
       Hot-Rod Internet Bench Racing Forum Index -> Engine and Drivetrain
View previous topic :: View next topic  
Author Message
34 pickup
Rookie


Joined: 20 Jan 2021
Posts: 42
Location: perth australia

Posted: Fri Aug 06, 2020 10:31 pm    Post subject: HYDRAULIC THROW OUT BEARING

Has anybody used a hydraulic release/Throw out bearing , this eliminates the use of a clutch fork and outside slave cylinder on a 4 speed gearbox , wondering if any body has used the Tilton brand hydraulic release bearing
thanks Phil
Back to top
AB
Rookie


Joined: 19 Jan 2021
Posts: 19
Location: S/E Melb.

Posted: Sun Aug 15, 2020 11:18 am    Post subject:

Phil

Have used hydraulic throw out bearings in Formula Fords with a lot of success, due to the limited space available.

rgds

AB
Back to top
Display posts from previous:   
       Hot-Rod Internet Bench Racing Forum Index -> Engine and Drivetrain All times are GMT + 10 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB 2.0.11 © 2001, 2002 phpBB Group